Author Topic: Hyperion 4035 motor  (Read 189 times)

DavidN

  • Jr. Member
  • **
  • Posts: 16
    • Email
Hyperion 4035 motor
« on: June 15, 2021, 03:34:08 PM »
Hyperion ZS4035 Kv:299rpm/volt. Low runtime. Perfect for 8s. Joint design/manufacturing project with Scorpion(SII 4035) with cosmetic differences.
Asking $125.

RCBushpilot

  • Newbie
  • *
  • Posts: 8
    • Email
Re: Hyperion 4035 motor
« Reply #1 on: August 30, 2021, 08:06:04 PM »
Do you still have this motor and could you send picture off the motor for specs as the numbers don't compare to the Hyperion site.  looking to run with 6s and would like to spec output in wattage
Thanks Jim

DavidN

  • Jr. Member
  • **
  • Posts: 16
    • Email
Re: Hyperion 4035 motor
« Reply #2 on: August 31, 2021, 09:27:53 AM »
Good morning, Yes I still have the motor. Max watts 2550 Max amps 95. Suggested lips 5-8s & continuous amps <85. NB Lipos have improved in C ratings since data was done, so check with a wattmeter.
2 websites for specs under the charts it is the Zs 4035 12 wind. Rotobirds is more detailed Hollein is original prop sheet.

http://www.hoellein.com/downloads/technische_daten/hyperion/ZS40propdata.pdf

https://www.robotbirds.co.uk/motors/motors/hyperion-motors/hyperion-new-zs-40-series/hyperion-zs-4045-12-247kv.html

Pic later.

DavidN

  • Jr. Member
  • **
  • Posts: 16
    • Email
Re: Hyperion 4035 motor
« Reply #3 on: August 31, 2021, 12:10:24 PM »

RCBushpilot

  • Newbie
  • *
  • Posts: 8
    • Email
Re: Hyperion 4035 motor
« Reply #4 on: September 01, 2021, 04:39:57 PM »
Thanks for your reply
When researching this is larger than will work for me and to do it justice more prop thank i can fit
Would be a great motor for a bigger plane

DavidN

  • Jr. Member
  • **
  • Posts: 16
    • Email
Re: Hyperion 4035 motor
« Reply #5 on: September 01, 2021, 08:29:56 PM »
Ideally this is an 8s motor although I Have 2 motors of 299Kv on 6s. 1 is a Hacker, the other is a Hyperion 4025. The first was because I needed nose weight & 2nd because I had the motor. A 3 blade prop is sometimes used to reduce diameter; but they are a pain to balance.
400-500 Kv is better for 6s.