Hyperion 4035 motor

[DavidN]

Hyperion ZS4035 Kv:299rpm/volt. Low runtime. Perfect for 8s. Joint design/manufacturing project with Scorpion(SII 4035) with cosmetic differences.
Asking $125.

[RCBushpilot]

Do you still have this motor and could you send picture off the motor for specs as the numbers don't compare to the Hyperion site.  looking to run with 6s and would like to spec output in wattage
Thanks Jim

[DavidN]

Good morning, Yes I still have the motor. Max watts 2550 Max amps 95. Suggested lips 5-8s & continuous amps <85. NB Lipos have improved in C ratings since data was done, so check with a wattmeter.
2 websites for specs under the charts it is the Zs 4035 12 wind. Rotobirds is more detailed Hollein is original prop sheet.

http://www.hoellein.com/downloads/technische_daten/hyperion/ZS40propdata.pdf

https://www.robotbirds.co.uk/motors/motors/hyperion-motors/hyperion-new-zs-40-series/hyperion-zs-4045-12-247kv.html

Pic later.

[DavidN]

[RCBushpilot]

Thanks for your reply
When researching this is larger than will work for me and to do it justice more prop thank i can fit
Would be a great motor for a bigger plane

[DavidN]

Ideally this is an 8s motor although I Have 2 motors of 299Kv on 6s. 1 is a Hacker, the other is a Hyperion 4025. The first was because I needed nose weight & 2nd because I had the motor. A 3 blade prop is sometimes used to reduce diameter; but they are a pain to balance.
400-500 Kv is better for 6s.